HYPER LIGHT

HY-3UN · in development

HYPER LIGHT Node

Three DMX512 ports on one Ethernet cable — Art-Net and sACN in, RDM out, and a page for the phone in your pocket.

Not for sale yet, and no date is promised. What follows is what has been seen working on a board — each line says where it is recorded — and what is still being built.

Proved on the bench

  • 3 × 42.6 Hz

    DMX512 outputs refreshing on the board, all three ports

    read from the node's own status page, firmware 2.0.0

  • 83,008 / 83,008

    Art-Net frames from the console, three universes, byte for byte

    captured on the node's board during an Academy recording

  • LAN · AP · Wi-Fi

    every network mode connects; RDM discovery and sequential addressing work in each

    field test on the board, firmware 2.0.0

  • Verified

    hardware binding on the board: a SHA-256 over the chip's own MAC and its serial number

    reported by the board's own security check, firmware 2.0.0

  • 30

    faders in the node's own DMX test, laid out for a phone held upright

    served by the board itself

Still being built

  • sACN (E1.31) proved on the wire with the node, beside Art-Net
  • RDM with fixtures from several makers on every port
  • A 24-hour soak at full universe load, and other consoles on the same network
  • Firmware updates from hyperlightdmx.com
  • Outputs that stay locked on a board whose binding does not match — built, not yet shown on a board

Art-Net and sACN from the console are taught in the Academy; Lesson 15 was recorded with the node’s board on the wire. To hear when the node is ready, write to us.